I made this stand from some scrap rebar and mild steel I had around the garage. I basically just heated the rebar with a oxy acetylene torch until bright red and bent it on a vise. The two supporting plates was MIG welded onto the rebar.
 |
| My Karnivor on the rebar marker stand |
 |
| This stand is very sturdy but if I were to make another one, I would have placed the side supports farther back closer to the paintball marker's center of gravity. |
 |
| I used rubber tape to cover all the areas of rebar that would make contact with my paintball marker. |
 |
| The length and angle is a bit unequal for the paintball tank support area, my next one will probably be better since for this one I made all my cuts and bends by eye. |
 |
| The side supports that keep everything upright is made from some scrap that I MIG welded together. |
MQ2 Valve
Tadao Yakuza Board
Palmers Fatty regulator
Invert Too loader
1 comment:
نقل عفش بالمدينة المنورة
نقل اثاث بالمدينة المنورة
شركة نقل عفش بالمدينة المنورة
شركة نقل اثاث بالمدينة المنورة
Post a Comment